Evs XT3 Version 11.00 Configuration Manual Manuale Utente Scaricare il pdf (Pagina 175)

Note

• For all protocols, except AVSP, use the channel assignment (PGM1 to

PGM6) instead of the device protocol type (Sony BVW75, Odetics).

• The AVSP protocol does not require any GPI IN setting in the setup menu

as they are defined through specific serial AVSP commands.

TTL GPIs set as GPIs

Description Defines the 4 configurable GPIs as inputs or outputs.

Values In / Out

Default value In

GPIs IN - Channel/Device

Description Specifies the server channel or the external device connected

to the corresponding GPIinput line, and therefore to which

channel or device the GPI will be sent to.

Values The following values are possible and correspond to one of the

channels or controllers assigned in the Channel and Control

settings (Channels tab, page 1):

• PGMx: The GPI is sent to the specified play channel.

• RECx: The GPI is sent to the specified record channel.

• RMTx: The GPI is sent to the remote controller.

• <Protocol Name>: The GPI is sent to the third-party

controlling device.

GPIs IN - Port

Description Specifies the RS422 port on which the server will receive the

input signal. This setting is relevant when the device is an

EVS remote controller or third-party controller.

Values The possible values are from 1 to 6: it corresponds to the

RS422 port to which the controller specified in the

Channel/Device field is assigned in the Port settings

(Channels tab, page 1).

169 3. Multicam Configuration

EVS Broadcast Equipment S.A. -April 2012 Issue 11.00.C

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 226 227

Nessun commento

Evs XT3 Version 11.00 Configuration Manual Manuale Utente Pagina 175